As we all know, when we use explosion -proof, we first need to install explosion -proof, and the installation will directly affect the use of the post -explosion -proof period.Lets learn the installation of explosion -proof warmth!1. For the requirements for the installation environment, first of all, we need to clean the surface of the basic concrete, check its horizontal degree, and then put the explosion -proof base on the basis.Ensure the mortar inflow.
2. When installing a general explosion -proof fan, you can also prepare several rectangular pads (steel plates) with different thickness. Adjust the explosion -proof airproof fans transmitted by a shaft can be adjusted with a shaft.Then welded and fixed.
3. The ground feet bolt holes through the ground bolt through the base should be perpendicular to the square holes of the foot bolts. In the gap between the ground foot bolts and the foundation of the base and the foundation concrete, they must be poured into a sufficient mortar to ensure the concrete to ensure the concreteThe strength of the structural component.
4. When we installation accuracy requires high explosion -proof fans, we should first pour the mortar into the holes of the foot bolts that are buried. After it is fully hardened, look for positive and adjust it to the level.Pour the slurry into the gap between the base and the foundation stick condensed so as to wait until the mortar is fully hardened, and the nuts of the foot bolt are fixed.5. The grouting process is very important for the installation of the explosion -proof fan.It not only plays a space between the base and the foundation concrete, but also has a great impact on the transmission of explosion -proof fan loads and the assistance of mechanical stiffness.Therefore, during construction, special attention should be paid to the shrinkage and breakability of the mud, and a reasonable construction method should be adopted.6. General large explosion -proof fans, the case is separated from the base.For section of explosion -proof fans, the case is divided into several parts.When installing, first install the explosion -proof fan base and bearing base according to the above method, and then install it in the order of the lower case, rotor, and upper case.7. In some cases, because sufficient foundation cannot be set, explosion -proof fans are often installed on the shock absorber to reduce the transmission of vibration.The compression volume is consistent.