The asphalt tank is a commonly used equipment for asphalt in the road -building project. So what should I pay attention to when the asphalt preheating produced by the boiled production?Let ’s listen to how the technicians of the asphalt tank manufacturer introduced it:
1. Open the big and small cover on the asphalt barrel.When you only need a bucket, you should open another hole in its relative direction so that the ventilation is out of oil.If there is water in the barrel, it must be cleaned first.
2. The operator should pay attention to the sudden spray of asphalt. If it is found that the asphalt ejaculates from the sand eye of the barrel, the side surface of the barrel should be covered with wet mud, and it should not be coated directly by hand.
3. If the asphalt bucket is blocked in the baking oil, the operator should stand on the side to dredge with an iron rod.
4. Use micro -fire when roasting, and you must not bake it with high heat.
5. The oil groove during the baked oil should be set up, and the passage of the oil storage cooker (pool) should be dredged.
6. If there is a stove at the bucket, the oil barrel should be rotated from time to time when the oil barrel starts at the beginning of the micro -fire.On top, the oil flows into the oil tank from small mouth.Together, set up a safe wall in front of the stove fire port and oil groove.
7. In the asphalt in the barrel, it often contains the water of the group. Before the asphalt flowing into the oil pan after the warmth, you should pay attention to remove the bright fire and avoid the increasing pot after entering the pot.