The ZTF-3F axis flow has been optimized. It adopts twisted blades, low-wind resistance motor brackets. It has the advantages of weight light consumption provinces and stable performance. It is suitable for ventilation in factory buildings, warehouses, office buildings, housing and other places.For a long passage, several series can be installed to improve the wind pressure.
ZTF-3F axis flowers are adapted to the sleeper length, and the chicken houses with short-circuit or heating up.
① When the back -end air is good, the air in the front section can be turned on at the same time as the back -end fan, and will be sent back to the front wet and humid air. It is discharged through the rear fan to achieve the normal ventilation effect.
② Do not turn on, the early stage of childcare, the temperature in the front section is appropriate, the back is low, it can be opened alone, and the front high temperature is sent to the back through the fan, and the temperature difference is reduced to less.
The installation process of ZTF-3F bearing fans:
1. Familiar with the samples of the fan, familiar with the specifications, forms, leaf rotation directions, and airflow direction of air flow in and out of the fans. Before installation, check whether the leaf wheels are touched and check the components.Strongly and carefully check whether the wind leaves are damaged or deformed due to transportation, otherwise it should be installed before it is repaired.
2. The air ducts that connect the fans should be supported by separate support. The weight of the pipeline is not allowed to be added to the components of the fan. Pay attention to the horizontal position of the fan when installing.Adjust the natural consistency, and it is not forced to connect.
3. After installation, pull the impeller by hand or leverage to check whether there is too tight or scratching, there are no items that hinder rotation, and there is no abnormal phenomenon before trying the trial movement.protecting mask.If the air inlet of the fan does not connect to the pipeline, the protective network or other security devices need to be added.
4. The wiring needs to be correct and reliable, the fan shell should be properly grounded, and the ground must be reliable.The supply of power is complete and meets relevant requirements.Electrical wiring must have a knowledgeable electrical wiring.
The above is the role and installation process of the ZTF-3F bearing fan. I hope it will be helpful to you.If you want to know more about related information, please pay more attention to us--