The refrigerator is a key equipment for air -conditioning units to cool down and damply. Generally speaking, the composition of the cooler is composed of copper tube and aluminum -winged slices.The heat exchange area of ??the refrigerator must be obtained after calculation. In the design, the designer should provide the air supply and the supply of freezing water to the supplier.Calculate and configure the refrigerator by the supplier.In terms of the design of the cooler, the water bulbs need to be set behind the equipment, and the water dish is set on the lower part of the cooler. The coagulation water and drainage should be smooth.Matching the pressure in the air conditioner.Because the depth of the cooler aluminum wing tablets is about 30 cm, aluminum -winged slices are arranged in a ripple, and the gap spacing is only 2mm.The dirt has oil adhesion, and it is difficult to rinse off with water. Therefore, when cleaning, you can only remove the front and rear water shields of aluminum wings, configure the cleaning agent.Rinse, this process is more time -consuming and laborious, but without the premise of other good ways, it can only be cleaned first to remove dirt and restore the thermal exchange efficiency of the system.Large -scale cooler integration system is a new subway ventilation air -conditioning system with simple forms, complete functions, saving machine rooms, and relatively low cost.It is a new subway ventilation air -conditioning system integrated through the sharing of equipment and air ducts to integrate the interval tunnel accident ventilation system and the ventilation air conditioning system of the station public area.At the same time, due to the use of frequency conversion speed regulation technology, the cooler manufacturer, adopting a reasonable control method, can achieve the ventilation seasonal variable volume operation and save a lot of power consumption.
The above is the cleaning method of the refrigerator. If you want to learn more about information, please pay more attention to us- ——