The design of the industrial warm structure is reasonable and beautiful, the bracket is stable and beautiful, with wall hooks, easy to swing, hanging, and lifting. The design of the backbird net cover effectively improves the efficiency of air inlet air, which is more conducive to motor heat dissipation and save corresponding space.
Interpret the application process of industrial heater for you:
1. Power plugs of the cable connecting the heaters with a relatively flat meter (please connect the power plug with a wire connector)
Second, the heater can make the surface layer firm, and to eliminate the wet and cold bad and flammable and explosive products.
Third, the power supply to connect the heater
4. Set the knob of the temperature regulator to a large value so that the heater can run at high power.
5. The heater will be connected to the heater to select the device.
6. The heater will automatically start and stop to keep the indoor temperature constant.
7. Once the room temperature meets the level, heating elements will stop working, but the fan will continue to work.Once the temperature decreases, heating elements will continue to heat.
8. Before turning off the heater, turn off the thermostat, and then rotate the knob. The heater will be closed and cooled within 2 minutes.
Nine, the increase in temperature controllers time is disconnected. If you forget to turn off the temperature controller at the OFF site, the temperature controller will be disconnected before turning off the heater, and the electric fan will continue to work.50 ° C.When the temperature drops to 40 ° C, the temperature controller and fan will terminate the work, and the opportunity of the wind will cool down.
10. After use, turn off the heater first, and then pull out the plug.
11. The temperature regulator is overheated or running abnormal. At the same time, it will fail. The non -self -reset temperature regulator will run, and the equipment will be closed.When you hear a clear click, it means that the circuit has been connected.