Single-speed ventilation characteristics: The centrifugal experiment is that the GBJ45-82 ventilation specifications have stipulated, and the corporate internal control guarantee mechanism that is higher than the specification is created.The price of single -speed stainless steel can be continuously run for 60 points at 300 ° C. It is not destroyed within 20 hours of 100 ° C. It is widely used in A industrial building, household ovens, underground parking lots, tunnel construction and other places.Stainless steel is suitable for ventilation or high -temperature ventilation of multi -story buildings, underground engineering, tunnel construction, and drying houses.It can continue to run more than 30 minutes at 280 ° C, and it will not be destroyed within 20 hours of temperature running at 100 ° C.It is an indispensable ventilation equipment for idealization.
Single -speed stainless steel fan is used as an insulation insulation countermeasure for the centrifugal fans. Embeds can recycling using centrifugal leaf wheels to force the motor to force the temperature according to the application to ensure that the motor temperature does not exceed the standard value of the specification.It can run for more than 100 minutes at 400 ° C, and run long -term development trends under 100 ° C.It can have the effect of ventilation.
Generally speaking, we know that the characteristics of high -temperature ventilation at this stage are: good thermal heat resistance, precision (precision) of the manufacturing of the case, and the precision (precision) of the manufacturing of the case should meet the requirements of the relevant standards.For the axis stainless steel fan, the motor supporting frame in the case should have sufficient hardness and bending stiffness to bear the dynamic load caused by the operation. The high and width ratio should be consistent with the core of the motor and the core of the case.In the end, you need to understand that the case of the high -temperature stainless steel fan of the axis streaming fan should be hot -dip galvanized, and the average value of the hot -dip galvanized layer of the stainless steel fan should not be less than 70 μm