Fire shaft
When installing a fire shaft flow fan, you need to follow the following steps and specifications:
1. Preparation before installation:
Fully understand the characteristics of the fan, and conduct a comprehensive inspection of the components of the fan, including the integrity of the machine, the direction of rotation, the tightness of the connection, and the damage of the main parts.
Prepare the necessary installation tools and materials to ensure that the installation environment meets safety requirements.
2. Installation steps:
Install according to the location and size shown in the drawings to ensure that the gap between the air inlet and the impeller is correct.
Use flexible non -combustible materials as a sealing gasket and ensure that it is installed in the correct position.
The air duct should be supported by independent support, and the pipeline weight should not be added to the fan components.The fan and the duct should be naturally connected and cannot be forcibly connected.
The wiring must be correct, good ground, and good power supply power supply.
After the installation, the transmission group is used to check whether there is too tight or collision with the fixed part.
3. Trial transport after installation:
All installation is completed, and after passing the general inspection, trial transportation is performed.
The trial transport is carried out in the case of no load (closing the gate or adjustment door in the wind pipe), and then gradually opens to the full load state.
The newly installed trial transportation time is not less than 2 hours, and the trial transportation of repair and installation is not less than half an hour.
Fire shaft flow fan maintenance
In order to ensure the normal operation and performance of the fan, the following maintenance work is required:
1. Clean appearance:
Regularly clean the wind turbine, including fan blades, shells and bearings, etc., to remove dust and oil stains.
The appearance is recommended to be performed once a quarter.
2. Bearing lubrication:
Bearing is an important part of a fan, affecting the service life and efficiency.
Check the use of bearings regularly, clean up and add an appropriate amount of lubricant.
Bearing lubrication is recommended to be performed once a quarter.
3. Electrical inspection:
The motor is the driver of the fan, which is responsible for power supply operation and adjustment speed.
Regularly check the use of the motor, including the power line connection, bearing wear, and the internal cleaning of the motor.
The motor maintenance cycle can be performed once a quarter.
4. Wind wheel inspection:
Wind wheel is the turning part of the fan, which requires regular inspections and maintenance.
Disassemble the wind wheel for surface cleaning to check the quality and operation of the wind wheel.
The wind wheel maintenance cycle can be performed once a quarter.
The above is the installation and maintenance of fire shaft flowers