It is a combination control system for warm indoor air, which is composed of automotive engine and heat pipe radiator.It is more suitable for all kinds of workshops that allow the indoor air.When the air does not include the dust concentration or flammable gas, it can be heated as the indoor air of the circulatory system.
We all have a variety of heating methods, such as ground heating, electromagnetic radiation, warm and humid airflow, and spreading heat.Among various concentrated heating methods, the centralized heating of indoor air is relatively comfortable. Heating fan is a relatively common indoor air concentrated heating method.The heater can ensure the warm air of clean air and dry air, so that the heating temperature of a whole space is evenly distributed.
1. Before installation and use, the data integrity of the general inspection of the high space heating unit should be effectively guaranteed.The exhaust device should have the corresponding pipeline equipment. Inlet and intelligent water return drainage riser should be installed and using the deeper valve. A whole pipeline equipment should be installed with gas water separators.If the air inlet of the exhaust fan can be directly connected with outdoor, a blocking control system should be installed at the outdoor advance air outlet to avoid cold and freezing when the thermal substance is terminated.
2. When the motor of the high space heating unit is connected to the switching power supply, the fans should be automatically rotated according to the direction of the equipment.The pipeline equipment of the exhaust device should be cleaned up, and it can be connected with the heater after cleaning.One drainage valve should be installed under each exhaust device.In order to better benefit the water flow of each exhaust device in the device, it is more powerful and the same programming design equipment.Before the application, the strong cold air in the pipeline equipment and heat pipe radiator pipes must be discharged.
3. The hot water temperature of the high space heating unit is usually more than 85, and the lower temperature should not be less than eighty.The flowing speed of hot water must be applied to the water flow speed in the heat pipe of the heat pipe to be more than 0.2m/s.Adjust the open angle of the shutters to obtain more suitable gas flow.In order to better manage the place, the main water inlet of the equipment can be installed and used to use a electric contact temperature table and a relay to concentrate the heater switch to prevent the factory from blowing strong cold air in the factory.