First, we must first prepare the corresponding square -meter cable connected to the warm power cord (please connect the power cord containing the ground wire). 2. In order to make the surface strong, keep it away from the humid environment and flammable items.Third, the power supply that connects warm.Fourth, set the temperature regulator knob to a larger, allow the warm power to run.5. Warm connection The heating selection device.6. Warm will start automatically and stop, so as to keep the indoor temperature constant.7. Once the room temperature reaches the required, heating elements will stop working, but the fan will continue to work. Once the temperature drops, the heating element will continue to heat.8. Before turning off the heater, open the thermostat OFF, then rotate the knob. The warmth will be closed and it will cool down within 2 minutes.Nine, the time of the temperature regulator is extended. If you forget to turn off the temperature regulator at the OFF position, the temperature regulator is cut off before turning off the heating, and the fan will continue to work. When the temperature of the heater is close to 50 ° C.When the temperature drops to about 40 ° C, the temperature regulator and fan will stop working, and the warmth will cool down.10. After use, first turn off the heater and pull out the plug.11. The temperature regulator is overheated or abnormal. At the same time, there will be a failure. The non -self -reset temperature regulator will be operated, and the equipment will be closed.Remove the plug on the socket to automatically cool the machine, and then use a steel needle to contact the non -self -reset temperature regulator button.When you hear a clear click sound, it means that the circuit is connected, insert the plug into the socket, and the main use step of opening the industrial warmth industry is these. Everyone must perform the correct operation according to the instructions. Only in this way can the performance be obtainedFully display