The maintenance of high -temperature smoke includes::
1. Keep the environment of the two -speed fire high -temperature smoke exhaust fan clean and neat, and keep the surface of the fan clean.There should be no debris in entering or outlet, and regularly remove the dusty dumplings in high temperature smoke exhaust fans and the pipelines.
2. It can only be operated under the normal operation of the dual -speed fire high -temperature smoke exhaust fan. At the same time, it is necessary to ensure that the power supply facilities are sufficient and the voltage is stable. It is strictly forbidden to run.The power supply line must be a line, and the temporary line should be used for a long time.
3. If the fan has abnormal sounds, severe heat fever, switching, charging, and unable to start during operation during the operation, it should be immediately shut down.
4. Replenish shaft supplement or replace lubricating oil according to the environmental conditions of the use (motor closed bearing does not need to replace lubricating oil during the service life period).1000 hours/time, closed bearing and motor bearings, and 2/3 of the inner and outer circles of the bearing inner and outer circles for ZL-3 lithium-based lubricants.It is strictly forbidden to operate oil.
5. High -temperature smoke exhaust fans should be stored in a dry environment to avoid moisture.If it is stored in the open air, it is necessary to take rain prevention measures.During the storage and handling process, the fan should be prevented from bumping to avoid damage to the fan.
6. Clean up the dust of the high temperature exhaust machine regularly.Prevent dust and other impurities from corrosion of the impeller.
7. Pay attention to power failure during the wind turbine maintenance.Check the sensitivity and standard oil the the thermometers on a regular basis.After each maintenance, except for replacement of lubricant, you should change the lubricant once a month under normal circumstances.
8. High -temperature smoke fan manufacturers The bearing cavity of abrasion -resistant bearing cavities of the blades of the manufacturer is higher than the bearing seat. The bearing seat will not be in contact with the cover of the cover.The tightness of the connection bolt is too large or the shaft is too small.The damaged current of the front and rear bearing electrodes is too large or the temperature rise.The shutdown volume of high -speed driver intake gates or throttle valves does not exceed the prescribed traffic.The density of the fan driving gas is too high, the input voltage of the adhesive motor is too low, the power supply single -phase power failure couplet is not connected, and the baffle is too tight or the gap is uneven.
The above is the maintenance of high -temperature smoke exhaust fan. Specific maintenance items may be different due to the different equipment models and use environment.It is recommended to contact professionals on a regular basis for maintenance and maintenance to ensure the normal operation of the equipment.If you want to know more about related information, please pay more attention to us--