In the following cases, work may be stopped:
Temperature reaches the set value: The heater has a temperature setting value. When the indoor temperature reaches this setting value, the heater will automatically stop working. After the indoor temperature is lower than the set value, the heater will start again.Work.This is to keep the indoor temperature constant.
Automatic power outage: The built -in dumping of automatic power -off protection protection function.When the heater is tilted by more than 30 °, the power supply will automatically cut off to prevent equipment damage and danger.At this time, the warm wind machine needs to be righteous and re -power to continue working.
Capacitor or motor failure: If the capacitor or motor of the heater fails, the heater cannot work properly.At this time, you need to replace the electric container or motor, or please repair professional maintenance personnel.
Circuit failure: If the heaters have been used for too long, circuit failures may occur, such as aging and short circuit such as electric wires, plugs, short circuit.At this time, you need to carefully check whether there are problems with the wires, power supply, etc., and seek help from professional maintenance personnel.
The air outlet filter is blocked: After the heater is used for a period of time, the air outlet filter may be blocked.At this time, the filter needs to be removed and cleaned to allow the heaters to continue working.
Disclosure status: If the heaters are in a downtime (instead of shutting down), it will not work.The stop state is usually because the machine is set as a standby mode, or the indoor temperature has reached the set temperature.
In short, there may be many reasons for the stop work of the heater, and it needs to be investigated and dealt with according to the specific situation.If you are not sure, please check and repair professional maintenance personnel.